| Hook load capacity, kN (òñ) | 2250(225) |
| Conditional drilling depth, m | 3900 |
| Drive type | electrical |
| Drive capacity, kV: hoist capacity | 630 |
| rotor capacity | 500 |
| pump capacity | 2 õ 630 |
| Hook speed, m/s | 0 ... 1,57 |
| Derrick | ÂÌÎ-49 × 225 with opened front side |
| Height of the derrick, m | 49 |
| Ultimate derrick height, m | 41,7 |
| Basement | Self-lifting |
| Height of the basement (from ground to the floor of drilling floor/up to support beams), m | 8,5 / 6,5 |
| Hoist | 080 DWP - 3 |
| Rotary swivel | UV-250 |
| Crownblock | UKB-6-250 |
| Block hook | UTBK-5-225 |
| Rotary table | Ð-700 |
| Mud pump | UNBT 950 L× 2 it. |
| Overall liquid total, m3 | 200 |
| Amount of purification stages | 4 |
Usage
This rig is intended for drilling of development wells for oil and gas with conditional depth 3900 m.
It has all the merits of fixed machines, quickly installable drilling rigs has several advantages presented below:
- Rapid installation;
- Convenient shipment because of weight reduction and module dimensions;
- Installation without using of building cranes;
- Installation on limited cluster sides;
- Possibility of transportation of loose modules by aircraft transport.
Components
- Derrick unit;
- Drawworks unit;
- Modular slush pump;
- Treatment unit, storage, processing, utilization and mortar preparation;
- Compressor unit;
- Power generating unit;
- Mechanized receiving bridge;
- Rail track;
- Additional metalware;
- Boiler house;
- Oil and water tank;
- Sectional communications.
Platform and basement lean on two ground supporting beams. Platform installation is made sectionaly with the help of special mounting arrangement, which is a platform’s component, and two catworks with carrying capacity 50 kN. Platform sections are put into the base together with mounted ladders and attics.
The basement is spread like parallelogram with the help of two catworks.
Height from floor to drilling platform is 8,5 m, overhead clearance for blowout preventer is not less 6,5 m.
Electrical drive of the main joints can be done on the basis of:
- Direct current motor;
- AC motor with frequency regulation.
- Contract supervision, electrical mounting, starting-up and adjustments of drilling rig;
- Personnel training of the customer to work on new equipment;
- Tracking of the pioneer well.
Shipment of drilling rigs is provided with rail modes and motor transport. First assembly and setting of all drilling rigs is carried out at presence of supervisor.
Services:
